ProSort™
from Eriez improves metal separation at a fraction of the
cost of air power metal sorters. Ideal for the scrap metals
market, the patent-pending ProSort airless
metal recovery system uses high sensitivity metal sensors
aligned with low energy electromagnetically driven paddles
to separate valuable metals from waste material.
ProSort
system advantages:
Easy
Access to Modular Components
The ProSort airless
metal recovery system features a simple elegant, easy to
operate design. The system's modular construction allows
easy access to replaceable sensors and paddle drive units
called "six packs." Each unit of six paddles and
six sensors operate from independent power supplies for
simple troubleshooting and diagnostics. Six packs are set
in a series to create up to 130-inch recovery system.
ProSort Components Include:
Low
Cost of Operation
By replacing expensive air compressor plants,
valves and airlines with energy efficient electromagnetic
drives, the ProSort airless metal
recovery system requires less than 25% of the electricity
needed to operate an air powered sorter.
Dual
Mode Segregation
ProSort's unique
modular design and alignment of sensors, paddles and controls
allows the components to operate in different modes during
a single cycle. Dual mode segregates waste material, ferrous
metals, non-ferrous and stainless steel in a single operation.
This illustration below shows half of the belt recovering
metals from waste, while the other side is sorting stainless
steel from non-ferrous metals. The zones shown can be adjusted
between all primary and zero re-run to more than half re-run
as the user desires.
Eriez
Recycling Equipment
Plate
Magnets, Chute Magnets, Suspended Magnets and Drum Magnets
Resource
Recovery Equipment
Metal
Detectors
Eddy
Current Separators
Vibratory
Feeders and Screeners
